prev
Next

新闻中心

创新、诚信、务实、高效

新闻中心
联系我们
英文

024-23609806 024-23609560

传真:0757-81802530

地址: 佛山市南海区狮山镇招大创业园创业中路5号

石材线条机的使用技巧(中英文对照)
发布时间:2015-08-31 14:43 来源:admin 阅读:
1, first with the diamond circular saw blade with rough machining, milling grinding wheel finishing, polishing. The wide or narrow shape this method suitable for normal bumps and relatively large. If the use of grinding wheel wear directly processing amount is large, and the saw blade with high cutting efficiency first remove most of the excess material, and grinding wheel grinding, fine grinding, polishing.
 
1、先用金刚石锯片铣刀刀片的粗加工和精加工,研磨轮,抛光。宽或窄的形状,这是正常的和合适的凸点的方法相对比较大。如果使用砂轮的磨损量是直接处理与大和效率高,切锯片的第一材料去除大部分的过剩和砂轮磨削,研磨,抛光精细,。。。。。。。
 
2, using diamond wire saw cutting, after copying machine polishing or manual polishing. It is suitable for processing larger wire, cutting can be obtained simultaneously concave, convex two kinds of yarn, such as good design, two kinds of flowers line can be used in a project, thus saving cost.
 
2,使用金刚石绳锯机切割,研磨或抛光后的复制操作。它是适用于更大的线切割加工,可同时获得两个凹、凸的种类(如纱,各种各样的花的好设计,两线可以用在该项目,从而节省成本。
 
3, with form grinding wheel directly processing. This is the most used for processing stone line, is the most economical, the highest efficiency of processing method. The yarn uneven undulating shape processing faster. It needs to make and to processing thread bump is opposite milling tools, in the stone line machine wear curve, the grinding wheel for rough grinding, fine grinding, polishing three, followed by the use of.
 
3、直接用砂轮磨削加工的形式。这是最常用的在线处理的石,是最经济的,最高的效率的处理方法。它对花线凹凸起伏不大的形状加工较快。它需要做的处理线程和对面的凹凸是一铣削工具,石材机械磨损曲线线在粗磨时,砂轮磨削,抛光精细。

地址:佛山市南海区狮山镇招大创业园创业中路5号
Copyright © 2010-2015 创金达机械 版权所有   

ICP备案号:粤ICP备15080176号